![]() With a plow it sometimes works but the trip or shear pin usually go first. Incidentally, the draft control is mostly useless in my experience. If they don't work put the long bar in from the top into the top link bracket and pull down. These instructions are from memory on a M7040. >releasing the lift on the long bar will allow the lower arms to drop back into position >the lower arms should move upward under hydraulic pressure >pull up on the long bar to move the top link bracket simulating compression of the top link Only have to lift the arms once manually and then it goes down. >take a long bar and place it between the top link pin and the top link bracket from the bottom With the arms down and control down, if you adj the draft from heavy to light the arms come up on their own even with the lift control in the down position, wont go back down until you adjust the draft to heavy and manually lift the arms again. >take off the top link and put the pin back in the top hole >put the 3PH lever all the way down (foward) ![]() >with the tractor running pull the lever nearest the seat (next to the 3PH lever) all the way to the rear There is an adjustment rod on the left side of the top link attachment point. My local dealer hasn't helped and after contacting Kubota directly, they referred me to my local dealer. I've read where there are 2 types - lower link and top link controlled.I've tried mine both ways (top link on the tractor mount and bottom (hole) link (of the 3 potential slots).neither works.Īny help / advise would be GREATLY appreciated. chisel plow.in my case) when the elevation changes and/or the implement encounters harder/softer soil - basically, saving the tractor from loss of horsepower or wheel spin. As I understand it, the draft control helps maintain the appropriate workload on the tractor by lifting ground engaging implements (e.g. I bought a new tractor (Kubota M9540) last summer and after much research (and having the Kubota dealer take it back to his shop for inspection), I do not believe the draft control is working properly. ![]() Probably too simple but maybe it got moved as you stated all of a sudden this started. Let me say upfront, I'm new to tractors/farming/tillage.bought some land and have built a Motocross track for my son and I to practice on here in TN. Is there a draft control lever next to the position control lever On mine if that draft lever is 80 or more of the way up it lifts the arms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |